If reusing the existing heatsink, clean the bottom of the heatsink with the alcohol pad provided in the spares kit. Remove the access panel Access Panel. Worldwide — Version 1 — December 22, How does HP install software and gather data? Intel Core 2 Quad Q Processor 2.

Uploader: Shaktigal
Date Added: 23 February 2008
File Size: 69.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 73155
Price: Free* [*Free Regsitration Required]

Let HP identify any out-of-date or missing drivers and software. Spare power supplies normally arrive set for V. Got it, continue to print.

Slide the drive in through the front of the chassis 1 until the screw holes on d2x810 drive are aligned with the screw holes on the drive cage and install the two M3 metric retainer screws 2 as shown in the following illustration.

Push down the latch on the side of the hard drive cage 1then slide the hard drive cage away from the bottom of the chassis 2 as shown below. Remove the four screws that secure the hard disk drive to the hard drive cage 1then slide the hard disk drive out of the hard drive cage 2.

After installing a new system board, always update the system ROM tm ensure that the latest version of the BIOS is being used on the computer.

Do not jam cables on top of expansion cards or memory modules. HP is compiling your results.


If you are adding a drive to an empty lower optical drive bay, you must remove the knockout plate from the bay. This page requires Javascript. Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.

System Board for HP Compaq Dx MT (microtower) PC | eBay

The Virtual Agent is currently unavailable. If you are not installing a new expansion card, install an expansion slot cover to close the open slot.

In flex mode, the channel populated with the least amount of memory describes the total amount of memory assigned to dual channel and the remainder is assigned to single channel.

Type 2 Battery Holder. Solution and Diagnostic Data Collection. To achieve the maximum memory support, you can populate the system board with up to 8 GB of memory configured in a high-performing dual channel mode. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged into an active AC outlet.

HP shall not be liable for dx2180 or editorial errors or omissions contained herein. When replacing the system board, you must also change the chassis serial number in the BIOS. Internal PC speaker MT. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services.

HP Compaq dx Microtower PC – Driver Downloads | HP® Customer Support

Apply the thermal grease provided in the spares kit to the top of the processor and install the heatsink atop the processor. The system will operate in single channel mode if the DIMM sockets are populated in one channel only. Page 14 1 Terms and conditions may vary by sx2810.


I don’t see my operating system. Choose ‘Refresh’ to update the list. After removing an expansion card, you must replace it with a new card or expansion slot cover for proper cooling of internal components during operation.

Heatsink retaining screws should be tightened in diagonally opposite pairs as in an X to evenly seat the dx2801 on the processor.

Asia Pacific and Oceania.

HP COMPAQ DX2810 Quickspecs

Comments to this Manuals Your Name. The HP-supplied standard screws 1 are silver.

Disconnect the power cable 1 and data cable 2 from the rear of the optical drive. Tell me what you’re looking for and I can help find solutions. Disconnect all power cables from the mass storage devices and from the system board.