The CPU will fit in only one orientation and can easily be inserted without exerting any force. You must press the Power button to power-on the system. Your system configuration amount of memory, add-in cards, peripherals, etc. Install the card-edge bracket to the system chassis then con- nect the audio cable connector to J The following fields will appear. The monitor has lost its vertical sync.

Uploader: Mezisida
Date Added: 9 October 2005
File Size: 62.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 52801
Price: Free* [*Free Regsitration Required]

If you are not using this function, set this field to Disabled.

DFI AZTL – motherboard – micro ATX – Socket A – KM Overview – CNET

Perform the upgrade instruction procedures described at an ESD workstation only. The system board requires a minimum of Watt power supply to operate. Once the CPU is in place, push down the lever to lock the socket.

The larger the range of the Cache RAM, the az300-tc/tl the efficiency of the system. To efficiently troubleshoot your system, treat each problem individually.

Pin 1 of the DIM module must correspond with Pin 1 of the socket. Joystick or MIDI port: Page 44 Hardware Installation 2. Select Disabled if you want to add a different hard az30-td/tl controller.

Seat the module vertically into the socket. The default settings will be loaded. Please read carefully the following information. Now install the card-edge bracket to the system chassis. Handle the CPU by its edges and avoid touching the pins.


DFI AZ30-TL – motherboard – micro ATX – Socket A – KM266

It utilizes a dedicated pipeline to access system memory for texturing, z-buffering and alpha blending. The modifications you have made will be written into the CMOS memory, and the system will reboot.

Other trademarks and registered trademarks of products appearing in this manual are the properties of their respective holders.

Instant-Off Pressing and then releasing the power button at once will immediately power off your system. These settings are not optimal and turn off all high performance features. Make sure that your printer is turned on and that the printer is on-line. Make sure aa30-tc/tl is sufficient air circulation across dri CPU fan and heat sink.

Includes high resolution mono- chrome adapters. Disabled The system az30-tc/tp not wake up despite access to the PCI card.

Connect an analog joystick to the pin D-sub connector Gold. The operating session will resume exactly where you left off the next time you power-on the system. It’s a community-based project which helps to repair anything. Connecting the Floppy Disk Drive Cable Install one end of the floppy disk drive cable into the shrouded floppy disk header FDD on the system board and the other endmost connector to the drive you want to designate as Drive A.


After completing the steps above and you want to power-off the computer, you do not need to go through the process of closing files, applications and operating system. The lever should click on the side tab to indicate that the CPU is completely secured in the socket. Make sure that the voltage selection switch on the back panel is set for the correct type of voltage you are using. Parallel Port Hardware Installation 2. Remove the jumper caps from pins and pins of J11 prior to connecting the front audio cable connector.

The value of the base memory is typically K for systems with K memory installed on the motherboard or K for systems with K or more memor y installed on the motherboard. Danger of explosion if battery incorrectly replaced. You may do this by using one of the 3 methods listed below.